PocketWizard AC3 ZoneController for Canon
Add the Pocket Wizard AC3 ZoneController for Canon to your on-camera MiniTT1 transmitter or FlexTT5 Transceiver and you gain 3 independent flash zones for even more control over your flash setup.
Three clearly labeled dials allow you to increase or decrease power to three zones of flash in 1/3-stop increments with a range of up to six stops. Three switches allow you to change zones between Manual, Auto (PowerTracking, E-TTL II, CLS/i-TTL) or OFF. Best of all, the design is simple with an intuitive interface. When matched with the PowerST4 or AC9 AlienBees Adapter, you can now control ElinchromRX*, White Lightning^ and AlienBees^ flashes right from the camera’s position.
Note: The AC3 requires firmware version 5.150 (or later) be installed on paired MiniTT1's and FlexTT5's.
* Elinchrom RX flashes require a PowerST4 Receiver. Note: Ranger RX requires EL-19374 EL Skyport Transceiver RX Adapter.
^ White Lightning and AlienBees flashes require an AC9 AlienBees Adapter and a FlexTT5 Transceiver on the flash.
This PocketWizard AC3 ZoneController for Canon Pocket Wizard comes with a full warranty in Australia. Pop into our Gold Coast camera store & warehouse or order online. #CamerasDirect, happily helping you take a better #photo and being at your service. Thank you.
|Name||PocketWizard AC3 Zone Controller for Canon|
|Manufacturer Part Number||PW-AC3-C|
Questions on PocketWizard AC3 Zone Controller for Canon
No questions asked yet